![]() ![]() CADWORX CONFIGURATION 07 CADWORX CONFIGURATION 1.- Select Apply Gasket Inser�on Rule, and then change the list to Automa�c. 5.- Type command UNITS in the file box, and change it to INCHES, ARCHITECTURAL, and clock turn. Current Drawing: 3D Enhanced shows more details in the drawing 4.- Under Configura�on Se�ngs, make sure SystemMeasure and Drawing Prototype are set to English/Inch (Metric/Metric). Alterna�vely, type SETUP on the command line, and then press ENTER. ![]() ![]() Piping components -> Gaskets DRAWING MANAGER 06 The layout for each project should be place in the Isometric directory -> Project folder -> Final Fab 1.- Open CADWORX 2.- Create a new drawing 3.- Click Setup on the Setup Size/Spec panel in the CADWorx Plant I tab. I-CONFIGURE File -> New -> New Project -> OK * Check the project is located theProject ISOMETRIC File -> New -> in New -> FOLDER previously created 4.- Edit Project Final Fab ISOGEN CONFIGURATION 02 3.- Create a new project Drawing Genera�on DRAWING MANAGER 03 Drawing Manager Diagnos�cs DRAWING MANAGER 04 Drawing Spli�ng Sheet Size & Template File * It depends of the Project requirements DRAWING MANAGER 05 Drawing File And change it in the Template FIle. MANUAL CADWORX 1.- Open I-Configure 2.- Create a new Isometric Directory: File-> New -> Isometric Directory -> New Folder I - CONFIGURE CONFIGURATION 01 ISOMETRIC CONF. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |